Servo motor needs to pay attention to many aspects when using，To ensure its normal operation and extend its service life。Here are some key considerations：

one、Environmental requirement

1. Waterproof and moisture-proof：The servo motor has no waterproof construction，Therefore, it must be waterproof、moisture-proof、Moisture protection，Avoid moisture or water from the motor。

2. Installation position：Avoid installing the servo motor indoors in the rain and direct sunlight，At the same time, do not place flammable materials around。In addition，The motor should be placed in a well ventilated place、Dry and dust free、Vibration-free site use。

3. Corrosive environment：Do not use corrosive gases（Hydrogen sulfide、Sulfurous acid、chlorine、ammonia、Chlorinated gas、acid、alkali、salt）And flammable gas environment、Use servo motor near fuel etc。

two、Installation and maintenance

1. Firmly installed：Make sure the servo motor is securely installed，Avoid vibration and loosening，At the same time, avoid the interference of the motor by external forces。

2. Parameter configuration：Depending on the motor model、specification、Set parameters for application scenarios，Ensure that the motor is operating in optimum condition。

3. Scheduled maintenance：Regular maintenance of the servo motor，This includes checking the motor housing for damage、Whether the screws are loose、Bearing wear and tear。meanwhile，Keep motor clean and dry，Avoid dampness and dust on the motor。

three、Operating specification

1. Follow procedure：When operating a servo motor，Operating procedures should be followed，Avoid misoperations and brutal operations。During operation，The speed of the motor should be adjusted according to the actual demand、Parameters such as position and load，Ensure the stability and safety of the motor。

2. Load matching：When choosing a servo motor，To ensure the maximum speed of the motor、Rotor inertia、Continuous load working torque and other parameters to meet the system requirements，To achieve a good match between the load and the motor。

four、Cable and connection

1. Cable protection：Do not immerse the servo motor cable in oil or water，And ensure that the cable will not be subjected to torque or vertical load due to external bending forces or its own gravity。In the case of servo motor movement，The cable should be firmly fixed to the stationary part，And use additional cable to extend it，To reduce bending stress。

2. Reliable connection：Ensure reliable connection between motor and driver and other components，Avoid faults caused by poor or loose contact。

five、Fault handling

1. Visual inspection：Check the appearance of the servo motor regularly，View motor housing、screw、Bearing and other parts are damaged or wear phenomenon。

2. Internal inspection：For servo motors with internal faults，A disassembly inspection is required，View internal parts（E.g. bearing、Gear wheel、Coil scheduling）Is there any damage?，And replace accordingly。

3. Software debugging：Use the software debugging function of modern servo motor control system，The speed of the motor、position、The load and other parameters are finely adjusted，Make the motor to achieve the best running state。meanwhile，The software debugging function can also diagnose and eliminate motor faults。

To sum up，The servo motor needs to pay attention to the environmental requirements when using、Installation and maintenance、Operating specification、Cable and connection and fault handling。Only by taking these factors into account，In order to ensure the normal operation of the servo motor and extend the service life。