My shopping cart

Quote
Cart0

The latest additions

There are no items in your shopping cart,Choose your favorite product quickly!
Scan
Current position: Home page > Information center > search
  • The basic requirements of CNC machine tool feed drive device

    introduction:The basic requirements of CNC machine tool feed drive device

    2016-01-06 Reading quantity 1667

  • The performance of CNC machine tool servo drive system

    introduction:The performance of CNC machine tool servo drive system

    2016-01-06 Reading quantity 2147

  • Application of servo technology in slow wire processing machine

    introduction:Application of servo technology in slow wire processing machine

    2016-01-06 Reading quantity 2226

  • Servo control system enables precise control of CNC machine tools

    introduction:Servo control system enables precise control of CNC machine tools

    2016-01-06 Reading quantity 2127

  • Connection of servo motor and reducer

    introduction:Generally speaking,Servo system manufacturers do not produce Reduction gear。Therefore, the servo electric and configured reducer is basically other brands of reducer,This reducer is specially designed for servo Motor matching reducer。 The connection between the reducer and the servo motor:The output shaft of the servo motor is extended into the reducer,The servo motor is connected with the reducer through the flange。Inside reducer

    2016-01-07 Reading quantity 1676

  • Comparison between servo motor and stepper motor and selection calculation method of servo motor

    introduction:one、Performance comparison of servo motor and stepper motor Stepper motor An open-loop control system,And modern digital control technology has an essential connection。In the current domestic digital control system,Stepper motor is widely used。With the advent of full digital AC servo system,Ac servo motors are also increasingly used in digital control systems。Adaptable to digital control

    2016-01-07 Reading quantity 1994

  • Transmission mechanism design of reducer

    introduction:Transmission mechanism of reducer|Hebei bridge star reducer factory Transmission mechanism of reducer Per gear,shaft,bearing,Mesh or synchronizer and shell, etc。 (1)Gear wheel Helical gear reducer Cylindrical gears have axial forces,But it still runs smoothly,Low noise,The outstanding advantages of long life are generally adopted,And most of them are equipped with synchronizer or rodent in the form of transmission of normally meshing helical gear

    2016-01-07 Reading quantity 1753

  • Common terms for couplings Couplings installation Maintain the working environment for couplings

    introduction:Common term for couplings Coupling installation and maintenance Working environment of the coupling Common term for couplings、Do you understand the installation and maintenance of couplings and the working environment of couplings?In case you werent already aware,It is necessary to read this article。This article will focus on the common terms of couplings、Coupling installation and maintenance and coupling working environment knowledge as a

    2016-01-07 Reading quantity 2295

  • What does the clutch do

    introduction:The clutch is located in the flywheel housing between the engine and the gearbox,Fasten the clutch assembly to the rear plane of the flywheel with screws,The output shaft of the clutch is the input shaft of the gearbox。While the car is moving,The driver can depress or release the clutch pedal as needed,Temporarily detach and gradually engage the engine and gearbox,Designed to disconnect or transmit engine input to a transmission

    2016-01-07 Reading quantity 2180

  • Five tips to easily eliminate the car clutch failure

    introduction:one、Fault phenomenon:When the engine is idling,The clutch pedal is pressed to the bottom,But its hard to get in gear,Theres a banging sound in the change gear。Barely in gear,The clutch pedal has not been released,The car is running or stalled。 two、Inspect:Remove clutch bottom cover,Put the transmission into neutral,Press the clutch to the bottom。then,Toggle the driven disk with the driver。If its easy to turn,said

    2016-01-07 Reading quantity 2303